Teledyne Princeton Instruments PICam 5.x Programmer's Manual page 83

Chapter 5
5.1.1.23 PicamParameter
Data Type
PicamParameter
Description
PicamParameter
Enumerator Definitions
Refer to
Table 5-23:
PicamParameter
Enumerator
PicamParameter_Accumulations
PicamParameter_ActiveBottomMargin
PicamParameter_ActiveExtendedHeight
PicamParameter_ActiveHeight
PicamParameter_ActiveLeftMargin
PicamParameter_ActiveRightMargin
PicamParameter_ActiveShutter
PicamParameter_ActiveTopMargin
PicamParameter_ActiveWidth
PicamParameter_AdcAnalogGain
PicamParameter_AdcBitDepth
PicamParameter_AdcEMGain
PicamParameter_AdcQuality
PicamParameter_AdcSpeed
PicamParameter_Age
PicamParameter_AnticiapteTrigger
PicamParameter_ApplicableStarDefectMap
ID
PicamParameter_AuxOutput
PicamParameter_BracketGating
Configuration APIs
is defined as
is the set of user-accessible hardware parameters.
Table 5-23 for enumerator definitions.
Enumerator Definitions (Sheet 1 of 11)
Controls the number of on-sensor accumulations
Controls the inactive number of rows on the bottom.
Controls the number of additional active rows that can be
used for storage.
NOTE: These rows cannot be imaged directly.
Controls the active number of rows.
Controls the inactive number of columns on the left.
Controls the inactive number of columns on the right.
Selects the shutter via the
enumeration.
Refer to
additional information.
Controls the inactive number of rows on the top.
Controls the active number of columns.
Controls the electronic gain of the pixel digitization via the
PicamAdcAnalogGain
Refer to
additional information.
Controls the resolution of the pixel digitization in
bits-per-pixel.
Controls the electromagnetic gain in terms of multiples.
Controls the nature of pixel digitization via the
PicamAdcQuality
Refer to
additional information.
Controls the rate pixels are digitized, in MHz.
Reports the age measured in minutes.
Uses an external pre-trigger to anticipate an external trigger.
Reports the ID of the star defect map that could be used for
pixel correction.
Controls the auxiliary output gate pulse.
Enables bracket pulsing for intensified hardware.
.
enum
Description
Section 5.1.1.1, PicamActiveShutter, on page 71 for
data enumeration.
Section 5.1.1.2, PicamAdcAnalogGain, on page 71 for
data enumeration.
Section 5.1.1.3, PicamAdcQuality, on page 72 for
data
PicamActiveShutter
83