Teledyne Princeton Instruments PICam 5.x Programmer's Manual page 84

84
Table 5-23:
PicamParameter
Enumerator
PicamParameter_CcdCharacteristics
PicamParameter_CenterWavelengthReading
PicamParameter_CenterWavelengthSet
Point
PicamParameter_CenterWavelengthStatus
PicamParameter_CleanBeforeExposure
PicamParameter_CleanCycleCount
PicamParameter_CleanCycleHeight
PicamParameter_CleanSectionFinalHeight
PicamParameter_CleanSectionFinalHeight
Count
PicamParameter_CleanSerialRegister
PicamParameter_CleanUntilTrigger
PicamParameter_CoolingFanStatus
PicamParameter_CorrectPixelBias
PicamParameter_CustomModulation
Sequence
PicamParameter_DelayFromPreTrigger
PicamParameter_DifEndingGate
PicamParameter_DifStartingGate
PicamParameter_DisableCoolingFan
PicamParameter_DisableDataFormatting
PicamParameter_EMIccdGain
PICam™ 5.x Programmer's Manual
Enumerator Definitions (Sheet 2 of 11)
Reports characteristics of a CCD sensor via the
PicamCcdCharacteristicsMask
Refer to
page 73 for additional information.
Reports the actual position of the center wavelength in
nanometers (nm).
Controls the target position of the center wavelength in
nanometers (nm).
Refer to
page 74 for additional information.
Reports if the center wavelength is moving.
Controls cleaning before each exposure.
Controls the number of clean cycles to run before acquisition
begins.
Controls the number of rows in a clean cycle.
Controls the final height rows for exponential decomposition
cleaning.
Controls the final height iterations for exponential
decomposition cleaning.
Controls the cleaning of the serial register itself.
Controls the nature of cleaning while waiting for an external
trigger.
Reports the status of the cooling fan via the
PicamCoolingFanStatus
Refer to
for additional information.
Enables pixel bias correction.
Customizes a modulation sequence.
Specifies the delay from pre-trigger to trigger in
microseconds (
Controls the second gate pulse in DIF readout in
nanoseconds (nS).
Controls the initial gate pulse in DIF readout in nanoseconds
(nS).
Enables/disables the thermoelectric cooling fan.
Controls the basic processing necessary to receive data in the
expected format.
Optimally controls the intensifier gain and electron
multiplication gain in emICCD hardware in terms of multiples.
Description
Section 5.1.1.4, PicamCcdCharacteristicsMask, on
Section 5.1.1.5, PicamCenterWavelengthStatus, on
data enumeration.
Section 5.1.1.7, PicamCoolingFanStatus, on page 75

S).
Issue 11
data enumeration.