Teledyne Princeton Instruments PI-MTE System Manual page 2

2
Revision History
Issue Date
Issue 6 October 1, 2019
Issue 5 October 22, 2015
Issue 4 November 12, 2013
Issue 3 February 3, 2009
Issue 2 March 23, 2006
Issue 1 February 26, 2003
Copyright 2003-2019
All Rights Reserved
All rights reserved. No part of this publication may be reproduced by any means without the written permission of Teledyne Princeton
Instruments.
Printed in the United States of America.
Kapton is a registered trademark of E. I. du Pont de Nemours and Company.
LabVIEW is a registered trademark of National Instruments Corporation.
Linux is a registered trademark of Linus Torvalds.
Macintosh is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
Pentium is a registered trademark of Intel Corporation.
Scientific Imaging ToolKit and SITK are trademarks of R Cubed Software Consultants, LLC.
Swagelok is a registered trademark of Crawford Fitting Company Corporation.
TAXI is a registered trademark of AMD Corporation.
VCR is a registered trademark of Cajon Company Corporation.
Microsoft, Windows, Windows XP, Windows Vista, and Windows 7 are registered trademarks of Microsoft Corporation.
The information in this publication is believed to be accurate as of the publication release date. However, Teledyne Princeton
Instruments does not assume any responsibility for any consequences including any damages resulting from the use thereof. The
information contained herein is subject to change without notice. Revision of this publication may be issued to incorporate such
change.
PI-MTE System Manual
Issue 6 of this document incorporates the following changes:
• Updated Chapter 2, PI-MTE System Overview as follows:
— Updated part numbers for Vacuum Compatible Flexible Tubing
and VCR fittings for ConFlat flange;
— Removed accessories that are no longer supported;
• Rebranded as Teledyne Princeton Instruments;
• Updated document to FrameMaker template.
Issue 5 of this document incorporates the following changes:
• Updated the Declaration of Conformity.
Issue 4 of this document incorporates the following changes:
• Removed information about heat transfer by means of conduction
with the outside case or external surface. The only acceptable means
of heat removal is by the use of flowing coolant.
• Updated OS Specs;
• Updated Warranty
Issue 3 of this document incorporates the following changes:
• Replaced warranty.;
• Added vacuum tubes and flange;
Issue 2 of this document incorporates the following changes:
• Added slide latch instructions to troubleshooting;
• Added VCR fitting information;
• Added ST-133B support.
This is the initial release of this document.
Teledyne Princeton Instruments
3660 Quakerbridge Rd
Trenton, NJ 08619
TEL: 800-874-9789 / 609-587-9797
List of Changes
Issue 6