Configuring Handshake And Kiss-Off - UTC Fire and Security Interlogix NX-535N Installation Manual

Configuring Handshake and Kiss-off

LOCATION 1 – Configuring handshake and Kiss-off (2 segments, numerical
data)
When the NX-535N module reports an event and the call is answered, the
system plays the leader message until the call taker acknowledges the call by
means of pressing a specific phone key. This option is called the handshake
digit.
The Kiss-off digit is the specific key that the call taker presses on the phone to
end the communication. It signals a successful report. The voice module will
acknowledge receipt of the correct DTMF kiss-off digit by playing the kiss-off
message (=message 17)
Segment 1 – Handshake DTMF digit
Segment 1 contains the Handshake DTMF digit to acknowledge the message.
Values can be as listed below:
Phone digit
0-9
10
11
12
15
Segment 2 – Kiss-off DTMF digit
Segment 2 represents the Kiss-off DTMF digit to end the communication. Values
can be as listed below:
Phone digit
0-9
10
11
12
15
If both Handshake and Kiss-Off are disabled then the sequence of leader, event
messages and address message are played 5 times before the report is
concluded.
8
Description
Sets a digit between 0 and 9
Sets the * button
Sets the # button
No Handshake is required
Any digit will be accepted as Handshake
Description
Sets a digit between 0 and 9
Sets the * button
Sets the # button
No kiss-off is required
Any digit will be accepted as Kiss-off
NX-535N Voice Module Installation Manual