Programming The Locations; Recording / Playing Back Messages - UTC Fire and Security Interlogix NX-535N Installation Manual

Programming the locations

Recording / Playing back messages

LOCATION 0 – Recording / playback selector (3 segments, numerical data)
Segment 1 – Recording / Playback selector
Segment 1 contains the selector whether you want to record, playback or cancel
the operation. Programming any value other than 0, 1 or 2 will be ignored.
Selectors:
0 Cancel the operation
1 Recording mode
2 Playback mode
Segment 2 – Event message selector
Segment 2 contains the individual event message selector. Herewith you can
select the message you want to record/playback. The leader message allows you
to indicate who is calling, in this case the alarm panel. The event message(s) will
be followed with an address message to identify the premise that is reporting the
event (alarm). You can record up to 15 event (alarm) messages. The event
message can be "kissed-off" by means of a DTMF tone from the telephone set.
Selectors:
0 Record / Playback leader message
1 Record / Playback 1st event message
2 Record / Playback 2nd event message
... .............................................
15 Record / Playback 15th event message
16 Record / Playback kiss-off message
17 Record / Playback address message
18 Reserved
While in record or play mode the user should only exit system programming
mode when finished recording/playing mode.
NX-535N Voice Module Installation Manual 7