Configuring Handshake And Kiss Off; Glossary - UTC Fire and Security Interlogix NX-535N-V3 Installation Manual

Configuring handshake and kiss off

Handshake and kiss off can be programmed as any key press or as a specific
telephone key. The following steps explain how to configure these digits.
Note: The voice protocol cannot generate a 'fail to communicate' signal.
1. Navigate with the  keys to NX-535 Voice Module>Handshake Digit and
press OK.
2. Select the handshake digit and press OK.
3. The keypad beeps once to accept the change.
4. Scroll to Kiss Off Digit and press OK.
• Select the kiss off digit and press OK.
• Select Any Digit to program any key press as the handshake/kiss off digit.
This is the default.
• Select None to disable kiss off.
5. The keypad beeps once to accept the change.

Glossary

Location Term
11 NX-535N-V3 Voice
Module
11. Recording
11.1.1 Leader Message
11.1.2 Single Event Message
11.1.3 Address Message
11.1.4 Kiss Off Message
11.2 Playback
NX-535N-V3 Voice Module Installation Manual
Definition
A module used to send pre-recorded voice
messages when activated.
A menu entry that groups recording options for
messages sent by the voice module.
A menu command that records the leader message.
This message is sent by the NX-535N-V3 voice
module at the start of a voice reporting phone call.
A menu command that records a single event
message. This message is sent by the voice
module and states the event that has occurred.
A menu command that records the address
message. This message is sent by the NX-535N-V3
voice module and states where an event has
occurred.
A menu command that records the kiss off
message. This message is sent by the NX-535N-V3
voice module at the end of a voice reporting phone
call to indicate that the kiss off digit has been
received.
A menu entry that groups options that allow the
installer to play back recorded voice messages.
6