Programming The Nx-535N Via The Lcd Keypad - UTC Fire and Security Interlogix NX-535N Installation Manual

Exiting a location
After the last segment of a location is programmed, pressing the [*] key will exit
that location, turn the "Ready" LED off and the "Armed" LED on. As before, you
are now ready to enter another programming location. If an attempt is made to
program an invalid entry for a particular segment, the keypad sounder will emit a
triple error beep (beep, beep, beep) and remain in that segment awaiting a valid
entry.
Exiting the program mode
When all the desired changes in programming have been made, it is time to exit
the program mode. Pressing the [Exit] key will exit this programming level and
then return to the "Select a Module to Program" level. If no additional modules
are to be programmed, pressing the [Exit] key again will exit the program mode.
If there is a module to be programmed, it may be selected by entering its address
followed by the [#] key (see "Selecting the Module To Program" above). The
procedure for programming these devices is the same as for the control panel,
except the locations will be for the module selected.
Note: The timeout for the program mode is 15 minutes.

Programming the NX-535N via the LCD keypad

All steps required for programming are the same as the aforementioned LED
keypad. The LCD keypad display will prompt you for the data required. While in
the programming mode, and not in a location, the number in parenthesis is the
location you were previously changing.
For example: if the display reads "Enter location, then # (5)", it is reminding you
that location 5 was the last location you programmed. Refer also to
"Programming Data" which follows.
Programming data
Programming data is always one of two types. One type of data is numerical,
which can have values from 0-15 or 0-255 depending on the segment size. The
other type of data, feature selection data, is used to turn features on or off. Use
the following procedures with these two data types:
Numerical data: Numerical data is programmed by using the numeric keys of
the system keypad to enter a number from 0-255. To view the data in a location,
a binary process is used. With this process, the LED's for zones 1 through 8 are
utilized, and the numeric equivalents of their illuminated LED's are added
together to determine the data in a programming location. The numeric
equivalents of these LED's are as follows:
NX-535N Voice Module Installation Manual 5