Header Tank Mount And Installation - BVM Go Fly Gold F-18C Assembly And Operating Manual


 There are some fuel line adapters that will
come with the twin engine version. This will
allow you to adapt your hoses to 6mm to fit
the BVM UAT. These need to be safety
wired in place.
 NOTE: The single engine version will differ
slightly and will not have the adapters.

HEADER TANK MOUNT AND INSTALLATION

 The header tank mount will have to be
glued into place. Scuff the area inside the
fuse with a BVM scuff board and wipe clean
with a rag and some denatured alcohol.
The header tank plate has a cutout in the
front. The Velcro strap is put on before
installing in the fuse and held in place with
medium ca glue. The tank mount is glued
into the fuse using BVM Vpoxy. This plate
will come with the header tank kit and will
be the same for the twin or single.
 Your header tank or tanks will have their
own manual for assembly. With the twin
remember to build a left and right tank.
NOTE: The tank in the photo is the right header
tank. Also safety wire or use your favorite
clamp to secure hoses in place.
BVM ®2021 13 10/2021