Table of Contents
Advertisement
2.3.2
Wall-Mounting
The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
Note!
When installing, make sure to allow for enough space to properly install
the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail
plate.
1.
Align the wall mounting plate with the rear side of the device. The screw holes
on the device and the mounting plates must be aligned, see the following figure.
2.
Secure the wall mount plates with the provided screws, see the following figure.
Once the wall mounting plates are secure on the device, you will need to attach
the wall screws (x 2).
3.
Locate the installation site and place the mount plate against the wall, making
sure it is the final installation location.
4.
Use the plates as a guide to mark the locations of the screw holes.
5.
Drill two holes over the marked locations on the wall, keeping in mind that the
holes must accommodate the width of the wall sinks in addition to the screws.
6.
Insert the wall sinks into the walls.
EKI-1511 Series User Manual
Figure 2.12 Installing Wall Mount Plates
13
Advertisement
Table of Contents
