Table of Contents
Advertisement
6.2.2
Accessing the Web Page via Web Browser
Once the device is installed and connected, power on the device. The following
information guides you through the logging in process.
1.
Launch your web browser on the PC.
2.
In the browser's address bar, type the device's default IP address (Eth1:
10.0.0.1).
The main menu is shown.
6.3
System
You can change the Device Name and Device Description on this page. You can also
enable or disable the Telnet and SNMP functions. Moreover, you can set the Time
zone related settings.
To access this page, click System.
The following table describes the items in the previous figure.
Item
Firmware version
Revision number
Device Name
Device Description
VCOM Ignore Device ID Click Enabled or Disabled to enable or disable VCOM ignore
Telnet
SNMP
Save
6.4
Ethernet Configuration
Choose Eth 1 in the Ethernet Configuration page. Enter the corresponding values for
your network environment. Remember press Save after fill in all values.
Figure 6.2 System
Description
Displays the current firmware version of the device.
Displays the revision number of the device.
Enter the device name: up to 31 alphanumeric characters.
Enter the device description.
device ID.
Click Enabled or Disabled to set remote access through the
Telnet Service function.
Click Enabled or Disabled to define the SNMP daemon.
Click Save to save the values and update the screen.
52
EKI-1511 Series User Manual
Advertisement
Table of Contents
