Table of Contents
Advertisement
2.3.2
Wall-Mounting
The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
Note!
When installing, make sure to allow for enough space to properly install
the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail
plate.
1.
Align the wall mounting plate with the rear side of the device. The screw holes
on the device and the mounting plates must be aligned, see the following figure.
2.
Secure the wall mount plates with the provided screws, see the following figure.
Once the wall mounting plates are secure on the device, you will need to attach
the wall screws (x4).
3.
Locate the installation site and place the switch against the wall, making sure it
is the final installation location.
4.
Use the wall mount plates as a guide to mark the locations of the screw holes.
5.
Drill four holes over the four marked locations on the wall, keeping in mind that
the holes must accommodate wall sinks in addition to the screws.
6.
Insert the wall sinks into the walls.
Figure 2.12 Installing Wall Mount Plates
12
EKI-1511L User Manual
Advertisement
Table of Contents
