Table of Contents
Advertisement
7.3.6
mdata
Usage: mdata
Show port mode and mode informations.
Usage: mdata [nn|all]
Set port [nn|all] as data mode.
Usage: mdata [nn|all] protocol [TCP|UDP]
Set transmit protocol as TCP or UDP.
Usage: mdata [nn|all] idleto [] lsport [] atport []
Set data idle timeout(s) listen port and AT command port.
Usage: mdata [nn|all] respto [] framebk []
Set response timeout(ms) and frame break(ms).
Usage: mdata [nn|all] bysize [] bytime [] bychar [NULL|] bychartimeout [ON|OFF]
Set datapackage as size (bytes) or time (ms) or character (HEX) and character-
timeout.
–
value 0: None Setting.
Usage: mdata [nn|all] autopeerip [ON|OFF]
Set auto connect to peer ip as on or off.
Usage: mdata [nn|all] peernum [1-16] peer [d.d.d.d:d] ...
Set peer IP address and port for receive data.
7.3.7
net
Usage: net [1|2]
Show device network status and informations.
Usage: net [1|2] mode [static|dhcp|bootp|all]
Set network operating mode.
Usage: net [1|2] ip [d.d.d.d] netmask [d.d.d.d] gw [d.d.d.d]
Set IP address and subnet mask and gateway.
Usage: net [1|2] dns [auto|specific]
Enable/Disable DNS.
Usage: net [1|2] dns1 [d.d.d.d]
Set network DNS1.
Usage: net [1|2] dns2 [d.d.d.d]
Set network DNS2.
Usage: net [1|2] to [d]
Set network timeout.
7.3.8
password
Usage: password
Display two different Usage.
Usage: password new [1-31 characters]
Set new password.
Usage: password old [**...] new [1-31 characters]
Confirm the old password and set new password.
7.3.9
alarm
Usage: alarm
EKI-1511 Series User Manual
73
Advertisement
Table of Contents
