AMX Modero X MXT-700 Operation/Reference Manual page 26

Installation
11.
Test the incoming wiring by attaching the panel connections to their terminal locations and applying
power. Verify that the panel is receiving power and functioning properly to prevent repetition of the
installation.
Do not disconnect the connectors from the touch panel. The unit must be installed
with the attached connectors before being inserted into the mounting surface.
12.
Latch the panel onto the top hooks on the back box and push it down (Landscape) onto the bottom snaps
or on the left side and push it to the right (Portrait) (FIG. 20). Press gently but firmly on the ends until the
snaps "click" to lock it down.
Mounting Surface
FIG. 20 Installing the MXD-700
If you see a gap between the panel and the back box, or feel any binding while
locking down the panel, stop immediately and verify that no cables or other items are
in the way. Do not force the panel into position, as this can cause damage to the
touch screen or the panel electronics.
13.
Reconnect the terminal Ethernet and USB to their respective locations on either the Ethernet port or
NetLinx Master.
20
Back Box
Latch Hooks
Snaps
MXD/T-700 7" Modero X Series® Touch Panels