Table of Contents
Advertisement
4.
Thread the incoming Ethernet from their terminal locations through the surface opening (FIG. 19). Leave
enough slack in the wiring to accommodate any re-positioning of the panel.
FIG. 19
MXD-700 Back Box Installation (Landscape)
5.
Remove the back box knockouts (FIG. 19) and thread the incoming wiring through the knockout holes.To
facilitate installation, thread the Ethernet cable through a bottom knockout (Landscape) or a right-side
knockout (Portrait), and the USB cable through a top knockout (Landscape) or left knockout (Portrait)
6.
Thread the incoming Ethernet and USB wiring (if USB access is desired) from the surface opening and
through the knockouts.
7.
Push the back box into the mounting surface. Insure that the locking tabs lie flush against the back box
and that the back box goes freely into the opening.
8.
Extend the locking tabs on the sides of the back box by tightening the screws inside the box until snug.
Not all of the tabs must be extended to lock the back box in place, but extending a minimum of the top
and bottom tabs is highly recommended. Apply enough pressure to the screw head to keep the box flush
with the wall: this ensures that the locking tabs will tighten up against the inside of the wall.
The back box is clear to allow visual confirmation that the tabs have been extended and are gripping the
wall, as well as in assisting with removal if necessary.
9.
For additional strength, #4 mounting screws (not included) may be secured through circular holes located
at the left and right sides of the MXD-700 (FIG. 19). In order to prevent damage to the touch panel, make
sure that these are flush with the back box.
10.
Insert each connector into its corresponding location along the back of the device (FIG. 15). To reach the
RJ45 connector, gently pull it from beneath the electronics cover (FIG. 16). Attach the Ethernet cable and
gently push the connection back under the cover.
To facilitate connection of the RJ45 connector to the Ethernet cable, press the RJ45's
cable into the RJ45 cable clip to hold it in a stable position. Make sure to remove the
cable from the cable clip before continuing the rest of the installation.
MXD/T-700 7" Modero X Series® Touch Panels
Locking
Back Box
Tab
#4 Screws
Installation
Mounting Surface
Knockouts
19
Advertisement
Table of Contents
