SRAM ROCKSHOX RUDY XPLR Service Manual page 22

12 Apply a liberal amount of grease around the air shaft. Apply a liberal amount of grease around the air shaft.
Install the seal head, retaining ring bottom out bumper, and bottom out Install the seal head, retaining ring bottom out bumper, and bottom out
platform onto the air shaft. platform onto the air shaft.
Install both pieces of the split keeper into the groove on the shaft, then Install both pieces of the split keeper into the groove on the shaft, then
install the split keeper o-ring. install the split keeper o-ring. Do not grease the split keeper o-ring.
Slide the bottom out platform over the split keeper and check that the
split-keeper o-ring is not visible.
13 Clamp the air shaft into the 10 mm slot in the Reverb Vice Blocks. Clamp the air shaft into the 10 mm slot in the Reverb Vice Blocks.
Install the air shaft stud Install the air shaft stud onto the air shaft and tighten. onto the air shaft and tighten.
Remove the air shaft from the vice. Remove the air shaft from the vice.
14 mm 3 N·m (26 in-lb)
22
Solo Air Spring Service