200 Hour Service; Lower Leg Seal Service - SRAM ROCKSHOX RUDY XPLR Service Manual

2 0 0 H o u r S e r v i c e
1
Remove the outer wire springs from the wiper seals. Remove the outer wire springs from the wiper seals.
Remove and discard the foam rings. Remove and discard the foam rings.
2 Stabilize the lower leg on a bench top or on the floor. Place the tip of Stabilize the lower leg on a bench top or on the floor. Place the tip of
a downhill tire lever under the wiper seal. Press down on the downhill a downhill tire lever under the wiper seal. Press down on the downhill
tire lever handle to remove the seal. tire lever handle to remove the seal.
Repeat on the other side. Discard the wiper seals. Repeat on the other side. Discard the wiper seals.
Keep the lower leg stable. Do not allow the lower leg to twist in
opposite directions, compress toward each other, or be pulled apart.
This will damage the lower leg.
3 Remove the bottom cup from the lower leg. Remove the bottom cup from the lower leg.
outside of the lower leg. outside of the lower leg.
4 Soak the new foam rings in RockShox suspension oil. Install the new Soak the new foam rings in RockShox suspension oil. Install the new
foam rings into the lower leg. foam rings into the lower leg.
L o w e r L e g S e a l S e r v i c e
NOTI CE
Clean the inside and Clean the inside and
Downhill Tire Lever
0w-30
Downhill Tire Lever
16

Lower Leg Seal Service