SRAM ROCKSHOX RUDY XPLR Service Manual page 12

8 Place an oil pan beneath the fork to catch the draining oil. Place an oil pan beneath the fork to catch the draining oil.
9 Use a 5 mm extension (minimum 110 mm length) to loosen the rebound Use a 5 mm extension (minimum 110 mm length) to
bottom nut and bottom bolt 3 to 4 turns. bottom nut and bottom bolt 3 to 4 turns.
10 Insert a 5 mm extension or hex wrench (minimum 110 mm length) Insert a 5 mm extension or hex wrench
into the bolt head of the spring side into the bolt head of the spring side lower leg. Strike the wrench to
dislodge the shaft from the lower leg. The bolt head should contact the dislodge the shaft from the lower leg. The bolt head should contact the
bottom of the lower leg. bottom of the lower leg.
Remove the spring side Remove the spring side bottom bolt. Clean the bolt and set it aside. bottom bolt. Clean the bolt and set it aside.
11 Insert a 5 mm hex wrench Insert a 5 mm hex wrench (minimum 110 mm length) into the
bottom nut bottom nut. Strike the wrench to dislodge the shaft from the lower leg. . Strike the wrench to dislodge the shaft from the lower leg.
Remove the rebound bottom nut Remove the rebound bottom nut. Make sure the crush washer is either
still in the rebound bottom nut or is no longer in the lower leg. Remove still in the rebound bottom nut or is no longer in the lower leg. Remove
the crush washer if it is in the lower leg. the crush washer if it is in the lower leg.
Clean the bolt and set it aside. Clean the bolt and set it aside.
loosen the rebound
lower leg. Strike the wrench to
into the rebound rebound
. Make sure the crush washer is either
Oil Pan
5 mm (minimum 110 mm length)
5 mm (minimum 110 mm length) & Mallet
5 mm (minimum 110 mm length) & Mallet
5 mm (minimum 110 mm length)
5 mm (minimum 110 mm length)
5 mm (minimum 110 mm length)
12
Lower Leg Removal