Terminator Resistors - Furuno FI70DSW Operator's Manual

5. INSTALLATION AND INITIAL SETTINGS
How to fabricate the cable and MC connector
Drain wire
Sheath Sheath
Core
5.2.4

Terminator resistors

Terminator resistors are required to close off the network ends, completing the
network.
The following FURUNO terminator resistors are available:
Part name
NMEA
Connector
Direct connection to the CAN bus/NMEA2000 backbone
Install terminator resistors to both ends of the CAN bus/NMEA2000 network backbone
cable.
5-8
Screw
Twist
MC connector
Type
LTWMN-05AMMT-SL8001
LTWMN-05AFFT-SL8001
LTWMC-05BMMT-SL8001
LTWMC-05BFFT-SL8001
SC-30
Terminator
CAN bus/NMEA2000 Backbone
Wire
Drain
Red
Black
White
6 mm
Blue
How to insert cores:
1. Twist the cores.
2. Unfasten the screw with Philips head screwdriver.
3. Set the core to hole.
4. Tighten the screw.
5. Pull the wire to confirm connection.
Code No.
000-160-508-10
000-160-509-10
000-168-604-10
000-168-605-10
Signal Connection
Point
SHIELD 1
NET-S 2
NET-C 3
NET-H 4
NET-L 5
Remarks
Mini connector, male
Mini connector, female
Micro connector, male
Micro connector, female
FI-70
Terminator