How To Adjust The Engine Settings - Furuno FI70DSW Operator's Manual

4.4

How to Adjust the Engine Settings

The number of engines aboard the vessel and which engine number is used as a
display data source are set from the [Engine Setup] menu.
Note: The following settings must be completed in order to display correct engine data
on the FI-70.
1. Access the [System] menu using the procedure outlined on page 4-1.
2. Press the software keys to select [Engine Setup], then press the function key.
3. Press the software keys to select [Number of Engine], then press the function
key.
4. Press the software keys to select the appropriate number of engines aboard the
vessel, then press the function key.
The FI-70 is able to display up to three engines' data. The [Number of Engine]
setting also changes the [Engine Setup] menu layout, as shown in the figure
below.
Engine Assign:
Engine Alarm
5. Select the engine number to be used as the data source.
Note: Engine number assignment must be done at the engine.
Where [Number of Engine] is set to [1]
[Engine Assign]: Select the engine to use as the data source.
Where [Number of Engine] is set to [2]
[Engine PORT]: Select the engine to use as the port-side data source.
[Engine STBD]: Select the engine to use as the starboard-side data source.
Engine selected
at [Engine PORT]
One engine
Engine
1
Ent
Eng. Temp. ºF
136
2600
Two engine display
Two engines
Engine
Engine PORT:
Engine STBD:
Engine Alarm
Ent
-16
°F °F
x1000 x1000
3320
4. SYSTEM MENU
Three engines
Engine
1 Engine PORT:
Engine STBD:
2
Engine Center:
Engine Alarm
Ent
Engine selected
at [Engine STBD]
1
2
3
4-5