Endress+Hauser Fieldbus Levelflex M FMP45 Operating Instructions Manual page 32

Operation
32
5.1.1 On-site operation
Options for on-site operation
• Display and operating module VU331
• Endress+Hauser operating software ("FieldCare")
Parameter access by on-site operation
The following parameters can be accessed by on-site operation:
• Parameters of the instrument specific blocks (Sensor Block, Diagnostic Block, Display Block)
• Endress+Hauser service parameters
• in the Resource Block: "Instrument Tag", "Instrument ID", "Instrument Revision", "DD Revision"
(read only)
Sensorblock
Diagnoseblock
Display-Block
Endress+Hauser
Service-Parameter
The highlighted parameters can be edited by on-site operation.
5.1.2 Remote operation
Options for remote operation
• FOUNDATION Fieldbus configuration tool (e.g. DeltaV or ControlCare)
• Handheld terminal Field Communicator 375/FC375
Parameter access by remote operation
The following parameters can be accessed by remote operation:
• Parameters of the instrument specific blocks (Sensor Block, Diagnostic Block, Display Block)
• Parameters of the FOUNDATION Fieldbus function blocks
Sensorblock
Diagnoseblock
Display-Block
Endress+Hauser
Service-Parameter
The highlighted parameters can be edited by remote operation.
Levelflex M FMP45 with FOUNDATION Fieldbus
Resource Block Arithmetik-Block
AI-Block 1 Input-Selector-Block
AI-Block 2 Signal-Charact.-Block
PID Block Integrator-Block
Resource Block Arithmetik-Block
AI-Block 1 Input-Selector-Block
AI-Block 2 Signal-Charact.-Block
PID Block Integrator-Block
L00-FMU4XXXX-02-00-00-YY-005
L00-FMU4XXXX-02-00-00-YY-006
Endress + Hauser