Table of Contents
Advertisement
3.
4.
5.
6.
The LCD displays:
Your MultiPASS 1000 begins receiving the document at the preset
time.
10-20
Special Sending Procedures
Use the numeric keypad to enter the time that you want to poll
the other fax.
Set the time using the 24-hour system. If the hour or
minute is a single digit, precede it with a zero. For
example:
07:30 = 7:30 a.m.
17:05 = 5:05 p.m.
If you make an error entering the time, press
enter the correct time.
Press
.
START/COPY
TEL=
Dial the fax number(s) you want to poll.
You can poll up to 97 destinations. See page 10-1 for
details.
Press
.
START/COPY
POLLING
TX/RX NO.
06/21/95
TIMER
The MultiPASS 1000 beeps once when the document is
received without errors.
The MultiPASS 1000 automatically redials if the other fax does
not answer or if the line is busy. (You can specify the number
of times it redials; see Auto Redial on page 5-17.)
If an error occurs during reception, the MultiPASS 1000 beeps
intermittently for a few seconds. If this happens, try polling
again.
To stop polling while receiving, press
If the
light is flashing, clear the error and press
ALARM
necessary, refer to Chapter 14, Troubleshooting.
CLEAR
XXXX
17:10
.
STOP
. Then
. If
STOP
Chapter 10
Advertisement
Table of Contents
