Users In Canada - Canon MP 1000 User Manual

USERS IN CANADA

PRE-INSTALLATION REQUIREMENTS FOR CANON
FACSIMILE EQUIPMENT
A. Location
B. Order Information
N
Canon recommends an individual line following industry
standards [e.g., the 2500 (touch tone) or 500 (rotary/pulse dial)
telephones]. A dedicated extension off a PBX unit without "Camp
On" signals is also permissible with a fax unit. Key telephone
systems are not recommended because they send non-standard
signals to individual telephones for ringing and special codes,
which may cause a fax error.
C. Power Requirements
NOTICE
The Canadian Department label identifies certified equipment.
This certification means that the equipment meets certain
telecommunications networks protective, operational and safety
requirements. The Department does not guarantee the equipment
will operate to the user's satisfaction.
vi
Supply a suitable table, cabinet, or desk. See Appendix A for
the unit's dimensions and weight.
1. Provide only a single-line to touch-tone or rotary
telephone set terminated with a standard 4-pin modular
phone plug. (Touch-tone is recommended if available in
your area.)
2. Order an RJ11-C modular jack (USOC code), which should
be installed by the phone company. If the RJ11-C jack is
not present, installation cannot occur.
3. Order a normal business line from your telephone
company's business representative. The line should be a
regular voice grade line or equivalent. Use one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL)
LINE IF YOU COMMUNICATE OVERSEAS
The power outlet should be a three-prong grounded receptacle
(Single or Duplex). It should be independent from copiers,
heaters, air conditioners, or any electric equipment that is
thermostatically controlled. The rated value is 120 volts and
15 amperes. The RJ11-C modular jack should be relatively close
to the power outlet to facilitate installation.
Contents