Advertisement
28 - Connect the cycling computer
Place the wire hanging off the front of the handlebars into
the Shimano Cable Tool TL-EW300 which is located in the
small parts box. Holding the cable tool, connect the wire into
the handlebar computer.
30
Tuck this wire into the wire wrap with the other cables to limit
the amount of wire dangling in front of the handlebars.
29
You will hear a click when the wire has been attached
completely.
31 - Install the pedals
Identify the left (drive side) right (non-drive side) pedals by
the markings on the threaded axle. The drive side (the side
that the chain is on) is clockwise threaded, the non-drive
side is counter clockwise threaded. Install the pedals on the
appropriate side.
9
Advertisement
