Advertisement
16
Place two washers on one of the M8 bolts. Starting on the
inside of the mounting plate and using just your fingers,
thread the bolt with the washers to the front boss until you
can not turn it any further. You should be able to thread the
bolt until you are certain it has engaged with the threaded
boss on the chainstay.
18
Make sure the holes in the mounting plate on the rear of the
KickBack line up with rear threaded bosses before tightening
all the way. Using the ball end of the Allen wrench, tighten the
two front bolts.
17
The reason for starting this off with just your fingers is to
insure that you do not cross thread the bolt since you may be
coming at it from a not ideal angle.
Once the first bolt is secured loosely, mount the second bolt
to the opposite front boss.
19
Place two washers on one of the M8 bolts. Starting on the
inside of the mounting plate and using just your fingers,
thread the bolt with the washers to the rear boss until you
can not turn it any further. Once the first bolt is secured
loosely, mount the second bolt to the opposite rear boss.
6
Advertisement
