Advertisement
32 - Install the RFA FootRests
Pick the RFA FootRest that corresponds to the side of the
bike you are installing it on. The flat plate is installed on the
bike frame towards the front of the bike and the clamping
ring is installed around the RearRack toward the rear of the
bike.
rear
Left FootRest
mounting
clamp
Right FootRest
34
To ensure the holes in the FootRest mounting plate line up
with the mounting holes in the frame, you will need to loosen
the bolts securing the RearRack to the frame. Using a 5 mm
Allen wrench, loosen these four bolts (two on each side).
There only needs to be a little bit of play in the rack. Do not
tighten these bolts down again until the FootRests are fully
installed.
33
Using a 4mm Allen wrench, remove the top of the clamp
located on the back end of the FootRest. Keep the top of the
clamp and the hardware nearby.
front
mounting
plate
35
Locate the installation front threads on the bike frame.
10
Advertisement
