System Memory - Dell E36S Series Owner's Manual

Figure 32. Installing the optical drive
1. SATA and power cable
3. optical drive
Next steps
1. Install the hard drive cage.
2. If disconnected, reconnect the disconnected data and power cables to the hard drives and optical drive.
3. Install the bezel.
4. Reconnect the peripherals disconnected from the control panel assembly.
5. Follow the procedure listed in
Related tasks
Removing the bezel on page 45
Removing the hard drive cage
Removing the optical drive blank and filler
Installing the optical drive on page 68
Installing the hard drive cage
Installing the bezel on page 46

System memory

Your system supports DDR4 ECC unbuffered DIMMs (UDIMMs).
NOTE: MT/s indicates memory module speed in Mega Transfers per second.
Memory bus operating frequency can be 1600 MT/s, 1866 MT/s, 2133 MT/s, or 2400 MT/s depending on the following factors:
• System profile selected (for example, Performance Optimized, Custom, or Dense Configuration Optimized)
• Maximum supported memory module frequency of the processors
The system contains four memory sockets — two sets of 2–sockets each. Each 2–socket set is organized into one channel. In each 2-
socket set, the first socket release lever is marked white and the second socket release lever is marked black.
After working inside your system
on page 53
on page 64
on page 54
2. release tab
4. hard drive cage
on page 43.
Installing and removing system components 69