Removing A Hard Drive Carrier From The Hard Drive Cage - Dell E36S Series Owner's Manual

Steps
Insert the hard drive cage into the system until it clicks into place.
Figure 18. Installing the hard drive cage
a. hard drive cage latch
b. hard drive cage guide screw (2)
c. hard drive cage
Next steps
1. If disconnected, reconnect the power and data cables to the hard drives and optical drive in the hard drive cage.
2. Install the bezel.
3. Reconnect the peripherals disconnected from the control panel assembly.
4. Follow the procedure listed in
Related tasks
Removing the bezel on page 45
Installing the bezel on page 46

Removing a hard drive carrier from the hard drive cage

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Disconnect all peripherals connected to the control panel assembly.
4. Remove the bezel.
After working inside your system
Safety instructions on page 42.
Before working inside your system
on page 43.
on page 43.
Installing and removing system components 55