System Board Jumper Settings - Dell E36S Series Owner's Manual

Table 19. System board jumpers and connectors (continued)
Ite Connector
m
6 Slot 2 PCIE_G3_X8 CPU
7 Slot 3 PCIE_G3_X1 PCH
8 Slot 4 PCIE_G3_X4 PCH
9 J_INTRU2
10 MB / Fan1
11 J_AMEA1
12 A1, A2, A3, A4
13 CPU_PWR
14 CPU
15 SATA 0–3/SATAe
16 SATA_ODD/SSD
17 SYS_PWR
18 PWRD_EN
19 J_SATA_2
20 CTRL_PNL
21 NVRAM_CLR
22 CPU_FAN
23 TPM
24 IDSDM
25 HDD/ODD_PWR
26 BP_SIG

System board jumper settings

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
For information about resetting the password jumper to disable a password, see the Disabling A Forgotten Password section.
Table 20. System Board Jumper settings
Jumper
PWRD_EN
NVRAM_CLR
Description
PCIe card connector 2
PCIe card connector 3
PCIe card connector 4
Intrusion connector
Cooling fan connector
iDRAC port card connector
Memory module sockets
CPU power connector P2
Processor socket
Mini SAS connector
Optical disk drive connector
System power connector P1
Password jumper
SATA connector 2
Control panel connector
NVRAM password jumper
CPU fan connector
Trusted platform module connector
Internal dual SD module connector
Hard drive power connector
Backplane signal connector
Setting
(default)
(default)
Description
The password feature is enabled (pins 1–2).
The password feature is disabled (pins 2–3).
The configuration settings are retained at system boot (pins 2–3).
The configuration settings are cleared at the next system boot. (pins 1–
2).
Jumpers and connectors 105