Removing The Optional Idrac Port Card - Dell E36S Series Owner's Manual

emulates a USB device. For more information, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/
idracmanuals.

Removing the optional iDRAC port card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
4. If connected, disconnect the network cable from the iDRAC port card.
Steps
1. Loosen the screw securing the iDRAC port card holder to the system board.
2. Pull the iDRAC port card to disengage it from the iDRAC port card connector on the system board, and remove the card from the
chassis.
Figure 44. Removing the iDRAC port card
1. iDRAC port
3. iDRAC port card connector
5. captive screw
82 Installing and removing system components
2. SD vFlash media card slot
4. iDRAC port card holder