Advertisement
AURA
handheld NIR - Rev. 2
®
Final steps
EN_40_070_0030I | AURA
handheld NIR - Rev. 2 | Maintenance and Repair Manual
®
2
Remove the halogen lamp
Unscrew the two Torx screws
Use a TX 8 Torx screwdriver for this.
Remove the retaining ring
Dispose of the old halogen lamp.
Fig. 9
Remove the halogen lamp
3
Install new halogen lamp
Put on cotton gloves.
Carry out the previous disassembly work steps 1 to 2 in reverse order.
Note
NOTE REGARDING ASSEMBLY
To avoid damaging the inside of the unit, use screw-holding tweezers to
insert the two screws on the base of the housing when reinstalling the
lamp holder.
See also "Fig. 8 Remove the lamp holder with halogen lamp" on page 14.
4
Calibrating the compensation data
The halogen lamp must be recalibrated after each lamp change.
5
To do this, read section "7 Calibrating the compensation data" on page 27
and carry out the work steps listed there.
Replacing the halogen lamp
from the lamp holder
1
from the old halogen lamp
2
4
3
2
1
.
4
.
3
15
Advertisement
