Table of Contents
Advertisement
2. Installation
• Avoid areas exposed to sudden temperature changes:
1) Areas directly exposed to cool air from an air conditioner.
2) Areas directly exposed to heat from a heater.
• Do not place the machine in areas where it can get exposed to corrosive gases.
• Do not install the machine at any location over 2,000 m (6,500 ft.) above sea level.
• Place the machine on a strong and level base. (Inclination on any side should be no more than 5
mm.)
• Do not place the machine where it is subjected to strong vibrations.
Machine Level
Front to back:
Right to left:
Minimum Space Requirements
Place the copier near the power source, providing clearance as shown:
The recommended 750 mm (30") front space is sufficient to allow the paper tray to be pulled out.
Additional front space is required to allow operators to stand at the front of the machine.
28
Within 5 mm (0.2") of level
Within 5 mm (0.2") of level
A (front): 750 mm (30")
B (left): 150 mm (6")
C (rear): 300 mm (12")
D (right): 450 mm (18")
Advertisement
Table of Contents
