ICP DAS USA uPAC-7186EG Getting Started page 49

To begin this process, click on the "Link Setup" icon in the "ISaGRAF Programs" window. When you click on
the "Link Setup" icon, the following window will appear.
COM number of PC
The "Target Slave Number" is the NET-ID address for the I-7188EG/XG &uPAC-7186EG controller. Default
NET-ID is 1. If you have more than one controller in the same RS-485 network, you have to change the
NET-ID to be unique in that system. To change the NET-ID, please refer to
The "Communication Port" is the serial port connection on your development PC, and this is normally either
COM1 or COM2.
The communication parameters for the target controller MUST be set to the same serial communication
parameters for the development PC.
For I-7188EG/XG &uPAC-7186EG controllers (serial port communications), the default parameters for
COM1 port are:
Baud rate:
Parity:
Format:
Flow control: none
Important Note:
It may be necessary to change the COM port settings for the development PC. Depending on which
computer operating system you are using, you will need to make sure that the COM port can properly
communicate to the I-7188EG/XG &uPAC-7186EG controller system.
Getting Started: PAC-7186EG(D) & I-7188EG(D)/XG(D), Jul 2020 V4.0
19200
none
8 bits, 1 stop
Section 3.4.
49
.