Table of Contents
Advertisement
ROI setting procedure:
1.
Choose a region of application.
2.
Press and hold the left mouse button and drag out a ROI (only one ROI can be set for each zone),
3.
Select Save to apply the ROI.
•
Region ID: Up to 8 ROI zones can be set in one bit stream.
•
Enable Region: Enable or disable the ROI.
•
ROI level: Select a bit stream for the ROI from worst (), worse (), bad (), normal (), better () and best ().
•
Non-ROI frame rate Fps: Set the frame rate outside of the ROI; the smaller the value, the higher the image
quality in the ROI. The frame rate range depends on the video standard and the resolution. It varies from 1 to 25
Fps. (Note: Different non-ROI frame rates may be given to different ROIs, but the lowest value among them will
be used as the frame rate applied to the non-ROI area on the preview frame.
10.2 RECORD PARAMETERS
10.2.1
REC PARAMETERS
Select Rec Parameters in the Record menu to go to page shown below.
This function allows you to control recording, pre-recording and type of recording (main stream and substream).
DS1099-047A
19
Advertisement
Table of Contents
