Appendix; Setup; Diagnostic (Diag) Parameters; Reset - Omega LVU800 Series User Manual

APPENDIX
Setup:
You can view how the LVU800 Series is configured.
1. From the main MENU level, press SETUP when VALUES appears.
2. When SETUP appears, press the SELECT key.
3. Setup will display the following information:
a. Units, Display, Rev mA, Safe, Height, Fill‐H
4. When completed, press SELECT when EXIT appears to return to the main program level.
Diagnostics (DIAG) Parameters:
This mode runs diagnostic tests that confirm operation of LVU800 Series. This mode should only be used
when supervised by an Omega Engineering representative.
Reset:
LVU800 Series enables the end user to reset the entire configuration back to the original factory settings.
Follow the instructions below to reset LVU800 Series:
1. From the main MENU level, press SELECT when VALUES appears.
2. When RESET appears, press the SELECT key.
3. When YES appears, press SELECT key to reset LVU800 Series.
a. To cancel the reset, press SELECT when NO appears.
4. When completed, press SELECT when EXIT appears to return to the main program level.
Factory Settings:
LVU800 Series
LVU809 Series
LVU816 Series
LVU826 Series
LVU832 Series
118.1" (300 cm)
216.5" (550 cm)
314.9" (800 cm)
393.7" (1000 cm)
HEIGHT
20
Step Seven
FILL‐H
114.1" (290 cm)
208.5" (530 cm)
307.1" (780 cm)
381.9" (970 cm)