Change Positions On The Drapery Track (Single) - Current Silent Trac Optional Programming Steps

For additional help during installation of your drapery track, visit www.currentproductscorp.com/support/drapery-track
I. Change Positions on the drapery Track (Single)
1. ENTER LEARN OPEN POSITION MODE
Change the open Position
Pull down and release the Pendant so the drapery moves towards
the direction you would like to set as the "open" position. See Figure
1.
After the drapery reaches it's current open position, it will stop
moving. Pull down and hold the Pendant for five seconds, or until
the drapery jogs. See Figure 2.
Release the Pendant.
2. SET THE OPEN POSITION
By hand, pull the drapery until it reaches the desired full open
position. See Figure 3.
Note: If you have a remote control paired to the device, you can use
it to move the curtain into the desired full open position. A press
and release will move the drapery half an inch in a direction while a
press and hold will move the drapery continuously.
3. EXIT LEARN OPEN POSITION MODE
Pull down on the Pendant once to exit learn mode. The drapery will
jog to confirm it has learned this position. See Figure 4.
or call 1-844-307-7435.
Figure 2 - Pull down and hold the Pendant for 5 seconds, then release
Figure 3 - Pull the drapery by hand to the desired full open position
2
Figure 1 - Pull down and release the Pendant
Figure 4 - Pull down and release the Pendant