Current Silent Trac Optional Programming Steps page 7

Change the Close Position for the window side drapery (Motor 2)
1. ENTER LEARN CLOSE POSITION MODE
Lift up and release the Pendant so the drapery moves towards the
direction you would like to set as the "close" position. See Figure
21.
After the drapery reaches the position, it will stop moving. Lift up
and hold the Pendant for five seconds, or until the drapery jogs.
See Figure 22.
Release the Pendant.
2. SET THE CLOSE POSITION
By hand, pull the drapery until it reaches the desired full close
position. See Figure 23.
3. EXIT LEARN CLOSE POSITION MODE
Pull down and release the Pendant once to exit learn mode. The
drapery will jog to confirm it has learned this position. See Figure
24.
Figure 21 - Lift up and release Pendant to move
Figure 22 - Lift up and hold Pendant for 5 seconds, then release
Figure 23 - Pull drapery to full closed position
Figure 24 - Pull down and release Pendant
7
drapery to closed position