Current Silent Trac Optional Programming Steps page 3

1. ENTER LEARN CLOSE POSITION MODE
Change the Close Position
Pull down and release the Pendant so the drapery moves towards
the direction you would like to set as the "close" position. See Figure
5.
After the drapery reaches the position, it will stop moving. Pull
down and hold the Pendant for five seconds, or until the drapery
jogs. See Figure 6.
Release the Pendant.
2. SET THE CLOSE POSITION
By hand, pull the drapery until it reaches the desired full close
position. See Figure 7.
Note: If you have a remote control paired to the device, you can use
it to move the curtain into the desired full close position. A press
and release will move the drapery half an inch in a direction while a
press and hold will move the drapery continuously.
3. EXIT LEARN CLOSE POSITION MODE
Pull down on the Pendant once to exit learn mode. The drapery will
jog to confirm it has learned this position. See Figure 8.
Figure 5 - Pull down and release the Pendant to close drapery
Figure 6 - Pull down and hold the Pendant for 5 seconds, then release
Figure 7 - Pull the drapery by hand to the desired full close position
Figure 8 - Pull down and release the Pendant
3