Table of Contents
Advertisement
Reinforce Adjacent Vertical Slat.
reinforce the top of the first vertical
Use
the
VERTICAL
slat before reinstallation [Fig. 14].
REINFORCEMENT TAPE
Reattach Adjacent Vertical Slat.
Carefully replace the slat back onto
the header hook by reversing the
steps to remove the slat [Fig. 15].
You have now completed installing your SMART WAND™. You may
now proceed to Programming the SMART WAND™ [Pg. 13].
12
BLIND
E
to
Figure 14, Reinforce Vertical Slat
Figure 15, Reattach Vertiacl Blind
PROGRAMMING THE
SMART WAND
For further assistance during programming, please view our online
instructional videos.
PROGRAMMING SLAT POSITIONS
When programming the SMART WAND™, you will be listening for
audible beeps to assist you through the programming steps. It is
a specific function in a programming stage. We recommend you
important to understand that each beep, or series of beeps, are for
minimize the noise within the room while programming the SMART
WAND™(s) to best hear these beeps.
NOTE: Be careful to not sum up the number of beeps you have heard,
for example, a SINGLE BEEP (1) and then a DOUBLE BEEP (2) is not a
TRIPLE BEEP (3).
During the programming phase, if an error is made, the SMART
WAND
will play a short tune. his means that you must restart the
™
programming steps for that SMART WAND
1. Placing the SMART WAND into Programming
Mode
To place the SMART WAND
™
into Programming
Mode, press and hold the PROGRAMMING BUTTON
b until you hear a DOUBLE BEEP(2), then release
[Fig. 16].
Prior to hearing a DOUBLE BEEP (2), you will hear
a SINGLE BEEP (1), then a DOUBLE BEEP (2).
After hearing THE DOUBLE BEEP (2), release. The
SMART WAND™ is now in Programming Mode.
™
.
™
Figure 16, Press and Hold
Programming Button
13
Advertisement
Table of Contents
