Current SILENT TRAC Quick Start Manual
Hide thumbs
Also See for SILENT TRAC:
- Installation manual (15 pages) ,
- Optional programming steps (13 pages) ,
- Setup manual (9 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Current SILENT TRAC
Summary of Contents for Current SILENT TRAC
- Page 1 Zigbee Setup with the Bridge (no App)
-
Page 2: Power Bridge
1A. Power Bridge • Find an outlet location • Insert the micro-usb end of the included power cable into the power port on the bridge • Plug the other end of the cable into an outet • Make sure the bridge is installed or placed 2ft above the ground... - Page 3 1B. Power Bridge • The LEDs on the bottom of the bridge will be solid red and green during startup • The LEDs will then turn solid red...
- Page 4 2. Put bridge in pairing mode • Push a tack or paperclip into the hole in the back of the bridge • Press and hold the recessed button for 5 seconds or until the LED begins to flash blue • Release the button...
- Page 5 5 minutes. When the LED turns red, pairing mode has ended. • On each Silent Trac you want to pair to the bridge, pull the pendant down once to start the curtain, wait one second, then pull down once to stop the curtain.
- Page 6 3B. Add remote to network • Be sure you are still in pairing mode. If needed, restart pairing mode by pressing and holding the back button on the bridge until the LEDs flash blue. • While in pairing mode, pull the “pull” tab from the bottom of the remote, or press and release a button.
- Page 7 4A. Pair remote to Silent Trac • Put the Silent Trac into pairing mode. • Pull down and release the pendant once to start the curtain, wait one second, then pull down and release the pendant again to stop the curtain.
- Page 8 4A. Pair remote to Silent Trac • Pair remote to Silent Trac • Select the channel by pressing and releasing the channel button until the corresponding LED lights up. • Use a tack or pen to press and release the button in the hole on the back of the remote.