Optional Programming steps for the Drapery Track Change Positions on the Drapery Track (Single) ..2 Change Positions on the Drapery Track (Dual) ..4 Pairing the Remote to the Drapery (FM) ..8 Enable or Disable Smart Assist ..9 Grouping Multiple Drapery Together (Control Box Required) ..10 Master Reset ..11...
“open” position. See Figure Figure 1 - Pull down and release the Pendant After the drapery reaches it’s current open position, it will stop moving. Pull down and hold the Pendant for five seconds, or until the drapery jogs.
Page 3
1. ENTER LEARN CLOSE POSITION MODE Change the Close Position Pull down and release the Pendant so the drapery moves towards the direction you would like to set as the “close” position. See Figure Figure 5 - Pull down and release the Pendant to close drapery After the drapery reaches the position, it will stop moving.
II. Change Positions on the drapery Track (dual) 1. ENTER LEARN OPEN POSITION MODE Change the open Position for the Room Side drapery (Motor 1) Pull down and release the Pendant so the room side drapery moves towards the direction you would like to set as the “open” position. See Figure 9.
Page 5
1. ENTER LEARN CLOSE POSITION MODE Change the Close Position for the room side drapery (MOTOR 1) Pull down and release the Pendant so the drapery moves towards the direction you would like to set as the “close” position. See Figure Figure 13 - Pull down Pendant to move room side drapery to closed position After the drapery reaches the position, it will stop moving.
Page 6
Change the open Position for the window side drapery (Motor 2) 1. ENTER LEARN OPEN POSITION MODE Lift up and release the Pendant so the drapery moves towards the direction you would like to set as the “open” position. See Figure Figure 17 - Lift up and release Pendant to move drapery to open position After the drapery reaches the position, it will stop moving.
Page 7
Change the Close Position for the window side drapery (Motor 2) 1. ENTER LEARN CLOSE POSITION MODE Lift up and release the Pendant so the drapery moves towards the direction you would like to set as the “close” position. See Figure Figure 21 - Lift up and release Pendant to move drapery to closed position After the drapery reaches the position, it will stop moving.
III. Pair the Remote to the drapery (FM) 1. INITIATE LEARN MODE Pull down and release the Pendant twice to enter learn mode. After the first tug, the drapery should start moving. The second tug should stop it. See Figure 25. Figure 25 - Pull down and release Pendant 2.
IV. Enable or disable smart assist Smart Assist allows users to pull the curtain manually and have the movement complete automatically. All drapery tracks come with Smart Assist enabled. 1. MANUALLY MOVE THE DRAPERY Begin with the drapery in the full open or full closed position. Manually move the drapery more than a foot towards the opposite direction.
The grouping feature is available on all units with a sensor box. Grouping allows users to control multiple units simultaneously V. Grouping Multiple Drapery Together with one manual command. Grouping also allows units to move together simultaneously when any one unit in the group has a sensor automated command triggered.
In some instances it may become necessary to master reset your drapery. Performing a master reset will restore the drapery to VI. Master Reset the Drapery its factory settings, erasing saved open and closed positions, groups, and all paired remotes. 1.
Warning: Changes or modifications not expressly approved by Current Products Co. could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.