Battery Exchange; Dust Collector Cleaning; Cleaning And External Maintenance Of The Device; Cleaning Infrared Sensors - Polaris WI-FI IQ Home Aqua PVCR 0735 Operation Manual

.
If the device is not used for a long time, it is recommended to charge the battery every 3 months, having
.
previously completely discharged it for which it is necessary to start the device in operation for the maximum
possible time.
It is recommended to charge the battery only when the device indicates that it will be discharged soon,
or when it is already completely discharged. It is better to turn on the device when the battery is fully charged.
.
The total battery life of the device with a new battery can be up to 150 minutes. Over time, this value may
decrease.
A damaged battery must be disconnected and disposed of.

BATTERY EXCHANGE

1. Turn off the device.
2. Place it with the bottom panel up.
3. Using a Phillips-head screwdriver (not included), unscrew the screws of the battery cover and remove the
cover by hooking it from the side of the screws.
4. Remove the old battery from the compartment and disconnect its connector for which click on the latch
of power socket of the vacuum cleaner and pull the battery connector out of it. To connect a new battery,
insert the battery connector into the power connector of the vacuum cleaner until it clicks. Carefully place
the battery in the compartment without pinching the connecting wires.
5. Replace the battery cover by inserting the plastic tabs into the holes. Tighten the screws.

DUST COLLECTOR CLEANING

- Press the button on the dust collector (Fig. 6)
- Remove the container by pulling the handle at the bottom
- Check for foreign objects stuck in the channels Remove them if necessary
- Turn over the container
- Open the lid of the container by releasing the latch
- Shake the debris out of the container, first remove the filter and HEPA filter to clean or replace
- Wash the HEPA filter after 15-30 days of use, depending on the intensity of use. Use the HEPA filter for no
more than 6 months, then replace.
- Dry the filters before installation (Fig. 8)
- Install the filter elements (Fig. 9)
- Close the container and reinstall it.

CLEANING AND EXTERNAL MAINTENANCE OF THE DEVICE

1. Before cleaning, make sure that the device is unplugged from the charger and that the charger is unplugged.
2. Do not immerse the device and charger in water or other liquids.
3. Do not use gasoline, alcohol or chemical solvents to clean the appliance.
4. Wipe metal parts with a clean, dry cloth.
5. Wipe the plastic parts of the appliance with a damp, wrung cloth. There should be no drops of water.
6. Keep the device in a cool, dry place.

Cleaning infrared sensors

Gently wipe the sensors with a soft cloth, without mechanical impact.
Side brush cleaning
1. Check for any damage and/or foreign substances in the brushes.
2. Wipe the brushes with a cloth dampened in warm water and wrung out well.
3. In case of damage to the side brushes, replace them in a timely manner.
Cleaning the main electric brush
The electric brush is designed to collect household dust from the floor and carpets using a rotating bristle roller.
Its design is very sensitive to clogging with long hair, fur, threads, etc. In the event of clogging, stop using the
vacuum cleaner immediately and take measures to clean the bristle roller.
31