COBHAM EXPLORER 710 User Manual page 166

Context management AT commands
The table below summarizes some of the most used AT commands for context management.
Parameters are explained in the table in the next section. For details, refer to the 3GPP standard
TS 27.007.
The context management AT commands can only be used over a BGAN connection
Note
and will not work on a cellular connection.
Command Parameters
+CGACT
+CGDCONT
+CGDSCONT [<cid>,<p_cid>[,<d_comp>[,<h_comp>]]]
+CGEQMIN
+CGEQREQ
+CGPADDR
+CGTFT
98-140012-H
[<state>[,<cid>[,<cid>[,...]]]
[<cid>[,IP[,<APN>[,<PDP_addr>[,<d_comp>[,<h_comp>[,<apn
uname>,<apn_passwd>]]]]]]]
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
[<cid>[,<cid>[,...]]]
[<cid>[,<packet filter identifier>,<evaluation precedence index>[,<source address and
subnet mask>[,<protocol number (ipv4) / next header (ipv6)>[,<destination port
range>[,<source port range>[,<ipsec security parameter index (spi)>[,<type of service
(tos) (ipv4) and mask / traffic class (ipv6) and mask>[,<flow label (ipv6)>]]]]]]]]]
AT commands
Appendix B: Command reference
157