Securam ProLogic B22 Operation Instructions Manual page 5

ProLogic B22
Note: with the B22 you have the opportunity to mask your code, in case someone is watching you
enter your code. On the EntryPad you can enter up to 9 digits – your 6 digit code plus up to 3
additional digits to mask your code.
For example, if your code is 1-2-3-4-5-6,

Enter 1-2-3-4-5-6 and Press Menu/OK button to open

Enter 3-4-1-2-3-4-5-6-7, where the 2 masking digits before your code (3-4) and the single
masking digit after your code (7) are concealing or masking your actual code.

If you enter less than 9 digits, you must always press the Menu/OK button to send the code to
the lock.

Note: the additional 3 masking digits can be added before and/or after your code.
3.0 Set Date and Time
3.1 Set Clock Time
Step1: Press the Menu/OK button
Step 2: At "My Menu", press the Menu/OK button
Step 3: The display will prompt you to enter a code, enter a valid Super or Manager Code, and
press Menu/OK.
Step 4: Scroll "▼" to the menu selection "Set Time" and Press OK
Step 5: Each of the elements of the date and time will flash when it is available to be set. Use the
"▼"or "▲" to scroll to the correct value and Press OK to move to the next element.
4.0 Code Management
The ProLogic B22 comes with two default codes:
•
Super Code (ID00) is 111111
•
Manager Code (ID01) is 123456
It is strongly recommended that both these default codes are changed before the lock system is put into
service.
Operation Instructions
5