Two or More ECR Configuration
Step 1: Using a serial cable, connect the 232A port on the first terminal to the COM 1 port on the first
ECR. Repeat for each additional terminal and ECR.
Step 3: Using the Ethernet cables, connect the ENET LAN port on each of the terminals to the 8-port
switch.
Step 4: Using one of the Ethernet cables, connect Port 8 on the switch to the merchant's Internet and
power up the switch.
Step 5: Using the terminal's power adaptor, connect one end to the Power port and the other end to the
power source/outlet. Repeat this step for each additional terminal.
st
Note: As of April 1
, 2020 Sterling/EVO no longer is running the Bridge software.
6 • Overview
SPS-300 SmartECR Supplement v1.11