Sam4s SPS-300 Series Manual page 11

Backing Up the Program to an SD Card
Note: To restore a program backup, the memory allocation settings must be set the same or higher as the
saved program. Be sure to print out the memory allocation when backing up so that it can be re-entered
before restoring the program.
S-Mode: press 5 X/TIME; press Page Down and press X/TIME again. Press CLEAR to return to the
main S-Mode menu.
1. Insert the SD card in the register's SD port. (The SD port is located inside the printer
compartment. Remove the security screw and open the flap securing the SD port. Insert the SD
card until you hear a click and the SD card is locked in.)
2. Turn the control lock to the S position.
3. From the second page of the Service Mode menu, select "9. SD Card Operation".
4. From the SD Card Operation menu select "1. Program Backup". The SPS-300 will write
the program files to the folder: SD:\SPS300\PRGBACK\S
the name programmed in system options page18.)
Saving Reports to an SD Card
Reports can be saved as *.rep file format for use by the 900 PC Utility or as *.csv file format that can be
opened with a spreadsheet application such as Microsoft Excel™. Saved reports are the current X1 report
readings.
Saved reports are the current X1 report readings, these reports cannot be restored to the register.
1. Turn the control lock to the S position.
2. From the second page of the Service Mode menu, select "9 SD Card Operation".
3. From the SD Card Operation menu select "3. Report Backup". The display offers two format
choices:
•
•
4.
The register will print confirmation of the successful report upload with the name of the report "UPLOAD"
for each report.
SPS-300 SmartECR Supplement v1.11
Press 0 to save in REP format. REP format is proprietary and can be viewed using the
SAM4s PC Utility
Press 1 to save in CSV format. This format can be read without conversion by many PC
applications, including Microsoft Excel™.
N (where store name is
TORE AME
SPS-300 Series Program Information • 11