Table of Contents
Advertisement
this is what the system is doing and we want to see clear drain water
Keep the inlet to the bypass open and make sure the outlet is still closed
These are the system start up and self-cleaning cycles and the duration:
Backwash
backwash
draw
draw
rapid rinse
rapid rinse
CAUtIOn:
Call customer service for assistance before making any changes that may affect the performance and life
expectancy of the system.
wARNING:
It is not advised to shorten these settings or increase the days between backwashes for proper iron
and/or manganese removal.
16.
Observe the drain water during the 5 minute rapid rinse cycle.
If the water is running clear - proceed to Step #17.
If the water remains grey - go back to Step #14 on Page 13
CAUTION:
Press the Cycle button and repeat the flushing
sequence until the water from the drain line runs clear.
water Treatment
wed
12:40 am
time to put the system in service and check your work
14 minutes
initially fills the tank
reminder:
open inlet completely after 1 minute when the it reads
lifts iron filtration media
flushes dust & fines
grey water should flow from the drain
40 minutes
saturates the iron filtration media
allows air valve to function properly to create greater oxidation
5 minutes
water should begin to flow from drain and prepares the filtration media
Note:
Check this cycle that drain water is running clear, see #16
If the drain water remains grey,
4000
1667
G
G
treatment
custom
minimum
1" air gap
System will now go back to the home Page
and is ready for service
nOtE: Upper right box will read 1667 g.
The valve is metered and the system will
self clean when 1,667 gallons are used or
on the 6th day at 1am, which ever
comes first.
14
13 m
0 s
look for clear
water coming
from the drain
Advertisement
Table of Contents
