Tank Fill Slowly; Flushing The System Procedure - Environmental Water Systems EWS-SPECTRUM-V2 Product And Installation Manual

flush the system and what the system is doing
START UP TO FLUSH THe SYSTeM
13. Press and hold the ReGeN Button until the
screen turns GReeN and reads BACkWASH 10:00
The Backwash & Rinse automatic self-cleaning cycles will run for a total of 20 minutes.
Th e cu rre n t cy cl e d i sp l ay o f e i th e r ba ckw a sh o r r i nse w i l l a l te rn a te
with the total regen time remaining screen for the self-cleaning backwash.
The system runs through the steps automatically. When finished, the last Green screen
will read: FILTERING. This will take a few moments and you will hear the valve reset
itself to provide treated water when the entire backwash process has been completed.
Valve return to Blue and Home screen when finished.
ONCe SYSTeM BeGINS TO BACkWASH
15.
SLOWLY OPeN THe INLeT
CAUTION:
Open inlet slowly and keep outlet closed.
NOTe: This cycle allows air to be purged from system while initially
filling the tank. Little or no water will be seen coming out of
the drain until tank has been filled completely.
NOTe: The remainder of the cycles will flush the system.
keeP THe INLeT OPeN AND MAke SURe THe OUTLeT IS STILL CLOSeD
This is the system start up and flush.
Backwash (10:00) & Rapid Rine (10:00) with total duration of Regen 20 minutes:
Cycle 1. Backwash:
Green Display will read and switch back & forth between BACKWASH 10:00 and the count
down and REGEN COMPLETED IN 20:00 and count down the total flush time.
After 10 minutes, valve will adjust and screen will change.
Cycle 2. Rinse: Green Display will read and switch back & forth between RINSE 10:00 and will count down
and REGEN COMPLETED IN 10:00 and count down the total flush time.
After 10 minutes, valve will adjust and screen will change.
Valve will tell you that it is heading home. Green Display will read FILTERING which is the service position. This takes
abount 30 seconds and you will hear the valve make several noises as it cycles which is normal.
Valve returns to the Blue Display and the Home Screen in the service position and pre-set next backwash in 10 days at
midnight as long as you have set the correct time of day
system is now flushing on its' own and you are almost done
bACKWAsH
10:00
MIN
open inlet only
during system
start up
NoTe:
day & Time are the only
changes needed.
system does not need any
additional programming.
Please follow the instructions
and allow system to run through
the pre-programmed start-up
and flush.
inlet
outlet
open
closed
View:
front/facing valve
Illustration Purposes only:
bypass not pictured
14