Table of Contents
Advertisement
flush the system and what the system is doing
START UP TO FLUSH THE SYSTEM
13.
Press the Extra Cycle button
screen will change to Cycle 1
14.
Once system begins to backwash
Slowly open the inlet only and keep outlet closed
CAUTION: Open inlet slowly and keep outlet closed.
NOTE: This cycle allows air to be purged from system while initially filling
the tank. Little or no water will be seen coming out of the drain until
tank has been filled completely.
NOTE: The remainder of the cycles will flush the system.
Keep the inlet open and make sure the outlet is still closed
These are the system start up and self-cleaning cycles and the duration:
Cycle 1. backwash: see steps 12 & 13 above.
This cycle will count down and last 10 minutes.
after 10 minutes, valve will adjust and screen will change.
Cycle 2. Slow Rinse: This cycle will count down and last 5 minutes.
after 5 minutes, valve will adjust and screen will change.
Cycle 3. Rapid Rinse: This cycle will count down and last 10 minutes.
after 10 minutes, valve will adjust and screen will change.
Valve will tell you that it is heading home.
Valve returns to the home screen.
In Service, Pre-set next backwash in 6 days and correct time of day
check the drain water and put the system in service
Extra
Cycle
button
CYCLE 1 00:09:59
BACK WASH
NoTe:
day & Time are the only
changes needed.
system does not need any
additional programming.
Please follow the instructions
and allow system to run through
the pre-programmed start-up
and flush.
inlet
to valve
valve
open
bypass
in raw
closed
water supply
CYCLE 1 00:09:59
BACK WASH
CYCLE 2 00:04:59
BRINE&SLOW RINSE
CYCLE 3 00:09:59
RAPID RINSE
VALVE MOVING TO
HOME POSITION
4#_
SRV 00:00PM
REGEN IN 06 DAYS
14
outlet
from valve
valve
closed
out filtered to
home or facility
Advertisement
Table of Contents
