Dantherm RCV 320 P2 Basic Manual page 37

INSTALLATION & SERVICE MANUAL FOR PROFESSIONALS
Installation: Mounting the device
Connecting the
Step Action
ducts
1
!
2
3
!
Dust hazard
Warning
WARNING
Ducts and connectors must be protected and kept closed until the house is ready to be
occupied. This is to ensure that no moisture, dirt or dust enters the ducts, which may cause
problems at a later stage.
Caution
Connect the ducts to the desired duct connections at
the top of the unit
Note: Make sure that the ducts, which you connect to
the unit, have the same or a larger diameter in compari-
son with the connector.
(The measurements can be seen in the Technical Data
section on page 52.)
All four ducts must be wrapped completely in a minimum of 50 mm insulation (in
heated rooms)
Determine the correct duct connections (A/B mode) on page 17 in order to know,
where to lead the different ducts.
Note: The installation of the ducts incl. duct dimensions, sound absorbers and insu-
lation must be done in accordance with national standards and building regulations.
Make sure always to calculate how much insulation is needed in the current installa-
tion. Contact your Dantherm distributor for further information.
Dantherm accepts no liability to water damages caused by an inappropriate duct
installation.
Illustration
37