Maintenance; Safety; Preparation; Restarting - Optimum OPTI turn TU 3008G Operating Manual

5

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the lathe.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long durability of the lathe and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the lathe and

damage to the lathe.
Only qualified personnel should carry out maintenance and repair work on the lathe.
Electrical systems and operating materials may only be installed, modified and repaired
by a trained electrician or supervised and under the control of a trained electrician and
must comply with electrotechnical regulations.
WARNING!
Do not climb onto or into the machine while working.
5.1.1

Preparation

WARNING!
Only carry out work on the lathe, if the main switch is switched off and secured against
restarting by means of a padlock.

Disconnecting and securing the lathe on page 15
Attach a warning sign.
5.1.2

Restarting

Before restarting, run a safety check.

Electronics on page 15

Safety check on page 13
WARNING!
Before starting the lathe, you must check that there is no danger for persons and that
the lathe is not damaged.
Maintenance
Version 1.1.6 - 2021-9-17 Translation of original instruction
TU3008G GB
67